Everything-Pools

Salt Pool Equipment

Monarch Pro Matic E-Series of Salt Chlorinator

The Monarch Pro Matic E-Series of Salt Chlorinators comprise a digital electronic regulated power supply to control an electrolytic cell and utilise low levels of common salt (less than half as salty as a human tear drop) to sanitise the pool water. The mild salt water is electrolysed using an advanced electronic process to automatically sanitise the pool water, even when you are away for extended periods. This means an end to purchasing chlorine.

The revolutionary ESC Series requires only 0.3% (3000 ppm) salt and has an intelligent self-clean cell system. This eliminates the need for manual cell cleaning providing virtual maintenance free operation.

There are currently 3 standard sizes avalible:

• BZc ESC16 Self Cleaning Unit for pools up to 17,500 gallons imp
• BZc ESC24 Self Cleaning Unit for pools up to 25,000 gallons imp
• BZc ESC32 Self Cleaning Unit for pools up to 40,000 gallons imp

For sizes larger than listed please contact Sales +33(0)4 68 91 17 50 email sales@everything-pools.com

Properties:

• Most Efficient and Economical Pool Sanitising System - ESC 16 - power consumption only 80 watts!
• No handling or storing of Chlorine
• Environmentally friendly. Salt is a natural product
• Fully Automatic, safe and simple to use
• Non Irritating to skin and eyes
• Sparkling clear pool water
• Mild Salt Water has therapeutic benefits
• Suitable for all pool surfaces
• Low salt and overload indicators
• Winter switch for cold water operation

Technical Info:

• Voltage rate: 230v 50 - 60 Hz.
• Maximum working pressure 2 bars.
• Maximum working temp. Call.
• Pipe size: 1.5 BSP or 50mm plain.
• In existing plant rooms with qualified engineer installation time less than 2 hours.
• Installation handbook supplied with each unit.

Monarch FAQS:

1. How long should I expect the Cell to last?
   On average, you should expect four seasons life out of your cell.
2. My Monarch does not seem to be producing any Chlorine?
   There are four areas to check:
   • Main power outlet switched off.
   • Pump not plugged into Chlorinator.
   • The Cell within the Unit is dirty.
   • Chlorinator not plugged into Pump.
3. Can a Monarch be used in a commercial pool environment?
   Yes, But not the ESC Range.

How Does a Salt Water Pool System Work?

Salt systems have three main components.

Salt
The first component is plain old salt. You have to have a minimum level of about 3000 parts per million of salt in the pool water. Salt makes the water conductive so that the electricity can pass between the plates in the cell. If the salt level goes too low, then the chlorine production simply stops. Salt is also the raw material from which the chlorine is produced.

Control Box
The control unit is a device that sends power to the salt cell. The unit controls how much chlorine is produced by regulating how long the power is applied to the cell. If you turn the control knob way down, then the unit might apply power to the cell only 25% of the time, thereby producing less chlorine. If you turn the control knob up, then the unit would apply power to the cell for a longer period of time. The amount of power applied to the cell does not increase or decrease.

The control unit will often sense the level of salt in the pool and indicate the need to add more salt.

Self cleaning units have a feature built into the unit that reverses the polarity of the voltage through the cell in order to clean any scale buildup off of the cell plates.

Salt Cell
The salt cell is a series of plates with opposite charges in a cell. As the water passes between the plates, electrolysis takes place, releasing the chlorine in the salt.